WinFence, Gcode Generator

• Allows the user to design posts and rails, either one sided or two.
• If two sided:
  • The second side can be the same as the first or different.
  • The sides can be viewed overlaid or side-by-side.
• Displays the output on a viewer so that the user can see what was
• created before cutting.
• Easy to set up and use.
• Allows the user to define the post/rail materials that will be used.
• Allows the user to define the hole configurations that will be used.
• Allows the user to define the bits that will be used.
• Holes can have offset (either positive or negative), alternate
• offsetting (to left and right), or no offset.
• Gives the user several options as to how the post/rail will be cut on
• the CNC machine. From the top or bottom, normal or inverted.
• Allows up to 4 spindles.
• Allows the user to define the spindle on/spindle off commands.
• The user can choose whether to use a fixed cutting depth or a varied
• cutting depth in order to prolong bit life.
• Allows the user to choose alignment of post on center, left edge, or
• right edge.
• After the user chooses the hole type, spacing, offset type and amount
• of offset, the Rails tab calculates the number of holes for you.
• The Rails tab allows the user to define Rise and Run.
• On Manual tab, the user can combine different types of holes,
• offsettings and spacings.
• Can be set to loop (cut one post normally, move over a set spacing,
• and cut another post back in the opposite direction.).

See our pricing page for more information about pricing on this product.